Fencing job after previous fence got damaged in a storm.
Fencing
Fence made of:
– 4″ fence posts
– metposts bolted down into a concrete.
– wooden gravel board
– featherboards for a close board panel
– lots of nails 🙂
Garden clearing
Garden clearing
I had to cut down a line of conifers and remove their roots.
Also to be removed two bushes
Below photos of what it looked like after
Tree roots removed as well.
Paul @Tidy Gardens
I never had any photos of myself working in a garden simply because there was no one to take them 🙂
However this weekend I did some work for a passionate photographer and he offered to take some for me!
Good or bad ?
Here they are..
Landscaping – preparing ground for caravan
Here’s some photos of a completed landscaping project to prepare ground for a caravan.
Fence repair – panel / post replacement
Fence repair
Timber fencing looks lovely and utilises a beautiful natural resource, but
inevitably it will rot. Pressure treated fence panels usually have a 10year guarantee and they will most probably last that time, but fence posts might not even last half of that time. The most important factor is the amount of moisture they are
exposed to over the years.
Fence repair – post replacement.
What you need:
- spade or better a fence post digger
- digging bar, ideally a jackhammer 🙂 – to break up concrete around the post
- some gravel to put at the base of a hole – help to drain water away from the post
- bag of postcrete – sets in around 20min
- spirit level
How to do it:
Dig out old post. Post hole depth = 1/3 of the length that will be above the surface.
Put some gravel at the base of the hole
Stick new post in
Make sure it’s level
Fill 1/3 of the hole with water and add postcrete
Cement will set soon so make sure post is levelled well.
Fence repair – panel replacement
How to do it:
Remove old panel, easy if you have a decent crowbar.
Stick new panel in and secure with galvanised nails ( 75mm ) or use fence panel brackets.
Sometimes it won’t be that easy. New panel might not fit in just like that. If the gap is slightly smaller than your new panel then you are going to have to cut it to size.
That’s fairly easy:
Take off ( pull nails out ) two vertical battens that run along the edge of the panel.
Cut off as much of the planks as you need.
Reattach battens.
Job done.
Testimonials
Steve
June 2021 Paul provides an excellent service he is knowledgeable and tidies up after himself. Thoroughly recommended
Lower Earley, Reading
